- Hydro-Carbon Filtration & Separation - http://www.hydro-carbon.nl -

Free water sensing in jet fuels and diesel

The AFGUARD free water sensor reflects the next generation of aviation fuel monitoring and is an important contribution to aviation safety. Its’ innovative sensor technology meets the advanced demands of today and tomorrow. Proper use will prolong the service life of 2″ monitor elements to 3 years. This translates into less maintenance and down time for fuelling vehicles, and is a huge cost saver. Some of the innovative features are:

T-009-0109The AFGUARD® is a measurement system, which supervises the quality of Jet Fuels. The AFGUARD® is recommended for insitu measurement of particulate matter in jet fuel like free water. The AFGUARD® is a scattered light sensor and is designed to provide inline control solution for a variety of processes. Functionality: A precisely defined, constant light beam penetrates the process medium. Scattered light from particles (undissolved liquids like free water or gas bubbles) in the medium is detected by photo diodes. It is also possible to determine a water slug in Jet Fuel. The AFGUARD® can be used perfectly to detect the functionality of filter water separators or to measure the water absorbing performance of filter monitors. This can be done by measuring the level of free water detected by AFGUARD® sensors, placed at the vessel inlet and outlet. Free water will be detected and, with AFGUARD® in place, the monitors are under constant surveillance to insure their proper function. Extended service life for FAUDI Aviation Elements could be a result – provided that the indicated differential pressure range is observed.

Technical data
– Measurement range 0 to 50 ppm or 0 to 100 ppm
– Accuracy +/- 3 ppm
– Linear analogue output signal 4 to 20 mA
– Contact Load DC 24 V DC
– Available variants intrinsically safe / safe area version
– Hazardous area approvals
– ATEX Ex II 1/2G Ex ib [ia] IIB T4
– ATEX Ex II 1/2G Ex ia IIB T4
– ATEX Ex II 3G Ex ic IIB T4
– Ingress protection IP 67
– Operating temperature -30 to + 60 °C
– Storage temperature -30 to + 70 °C
– Relative humidity 10 to 90 %
– Pressure range 10, 16 bar
– Wrench size AF 36
– Torque 50 Nm